FAQ
From which quantities can you order from us?
The smallest surface that you can order is 280x370mm.
Which plate sizes, can you still send with the parcel service?
To enable shipping with a parcel service, the following rules are apply:-The package can not be longer than 2.00 meters.
-The length of the package + the belt circumference (height + width + height + width in meters) must not exceed 3.00 meters.
For example, you would like to order a 10mm thick plywood board, with measuring 2.00 meters in length, then the width
of the plywood board should not be more then 0.45 meters:
2.00 meters long + 0.45 meters wide + 0.01 meters high + 0.45 meters wide + 0.01 meters high = 2.92 meters
(we also need some clearence for the packaging)
of the plywood board should not be more then 0.45 meters:
2.00 meters long + 0.45 meters wide + 0.01 meters high + 0.45 meters wide + 0.01 meters high = 2.92 meters
(we also need some clearence for the packaging)
How should I mark the course of the joints when placing an order?
This is quite simple because: The first measurement is also the specification of the joints length.Order a board with an measurement indication of e.g. 200x150mm, then the joint on the 200mm:
A measurement indication of 150x200mm, takes the joints runs to the 150mm:
Can you cut marinedeck panels also for stencils or templates?
Yes, of course, the cutting, for example, trapezoidal surfaces, arcs or curves according to dimension or template is possible.The calculation is based on time expenses.
What is HPL?
HPL, short form of "High Pressure Laminate" are simply printed papers that are bonded with high pressure and with the help of resins. The resulting plastic is short-term resistant to heat and scratches and is easy to care for and clean. HPL panels have arrived in many areas of our lives. Their often very real-looking decors can be found in furniture and kitchen, ceiling, wall and floor areas, as facade elements, etc.
Can you also doubling marinedeck panels with plywood?
On request, we will doubling marinedeck panels plates with additional mahogany rotary cut plywood, for example to make lids or engine compartment flaps.And an additional lamination with HPL plates below the doubling is possible.